Product manual

Page 5For technical questions, please call 1-800-444-3353.SKU 42950
Assembly
The Trailer Jack requires no
assembly, but care must be taken
to properly mount the Trailer Jack to
the trailer. The Trailer Jack design
requires that the Swing Plate (8) be
securely welded to the side of the
trailer’s tongue with the lip of the
Swing Plate (8) above the tongue for
added support.
WARNING: To insure safe
operation, welding of the Swing
Plate (8) to the trailer tongue must
only be done by a certied welder
in a safe location, away from all
ammable materials.
Plan the location of the Trailer Jack.1.
Examine both sides of the trailer 2.
tongue and choose the appropriate
location for the Jack, keeping in mind
the mounting method, and the need
to crank the Handle (1).
The Trailer Jack is designed to be 3.
welded to either side of the trailer
tongue, and will swing back in either
direction (forward or to the rear).
Leave adequate room at both sides
of the trailer frame so as to allow
horizontal positioning of the Jack, in
either forward or rearward position.
Before installing the Trailer Jack, 4.
properly support the tongue of the
trailer so that it is high enough off the
ground to provide clearance for the
Jack. Take precautions to insure the
wheels of the trailer are chock and
will not roll.
Remove Retaining Ring (7) and 5.
detach the Swing Plate (8). Carefully
remove the paint from Plate edges.
Position lip of the Plate over top of
the trailer tongue and commence
welding. Once the Swing Plate (8) is
properly welded to the trailer tongue,
attach the Jack to the Plate and
secure in place with the Retaining
Ring (7). Test the Trailer Jack to
make sure it functions correctly.
Crank the Handle (1) both ways to 6.
make sure the Trailer Jack extends
and retracts properly.
Pull out the Pull Pin Handle (9) and 7.
swing the Trailer Jack upward to
horizontal position. Make sure the
Pull Pin (10) engages into the Swing
Plate (8) and locks the Trailer Jack in
this upward position.
After you have tested the Trailer 8.
Jack and are condent of it’s proper
operation, the Trailer Jack is ready for
use.
Note:9. Always have the open end of
the Rotarting Pin (13) pointed to the
jack.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Mount and dismount Trailer only on
smooth, level surfaces.
Swing
Plate (8)
Trailer
Tongue