Product manual

Page 8 For technical questions, please call 1-800-444-3353. Item 61484
SAFETY OPERATION MAINTENANCESETUP
Head to Column
1. Before installing the Head Assembly, it may
be necessary to back the Set Screws (6)
out slightly to ensure they do not protrude
internally, as this would prevent the Head
Assembly from sliding fully into position.
2. With assistance, raise the Head assembly
and locate it on top of the Column.
3. Align the Head with the Base, and firmly
secure it with the Set Screws.
4. Screw the three Spindle Feed Handle Bars (93)
firmly into the Spindle Feed Handle Seat (94).
Installing the Chuck
1. Loosen the Arm Locking Handle (18) and slide
the Table up the Column to within 6″ of the
Arbor (32). Tighten the Arm Locking Handle.
2. Thoroughly clean the Arbor and the
tapered hole in the Chuck (31) of all dirt,
grease, oil, and protective coatings.
3. Slide the Chuck onto the Arbor.
4. Examine the Chuck from all sides
to make sure it is straight.
5. Open the jaws of the Chuck to their
maximum, using the supplied Chuck Key.
6. Put a piece of scrap wood on the
table to protect the Chuck nose.
7. Using the Spindle Feed Handles, lower the Spindle
and press the Chuck nose hard against the
scrap wood on the table until the Chuck is forced
into a solid fit. The Chuck is pressure fitted..
Installing the Cutting Oil System
1. Use four Socket Head Cap Screws (73) and four
Flat Washers (74) to attach the two Oil Bottle Clips
(75) to the tapped holes in the left side of the Head.
2. Thread the Oil Pipe (53) into the bottom
of one of the Oil Bottles (28), screw an Oil
Bottle Cap (25) onto the Bottle and snap
the Bottle into the Oil Bottle Clips.
3. Assemble an Oil Bottle Top, Sealing Gaskets
A and B (26, 24) and Hollow Connecting
Bolt (27) together as shown in Figure C.
Oil Bottle
Cap (25)
Sealing
Gasket A
(26)
Sealing
Gasket B
(24)
Hollow
Connecting
Bolt (27)
Figure C
4. Screw the Bottle Cap assembly into the threaded
hole in the underside of the Work Table. Tighten
the Hollow Connecting Bolt enough to compress
the Sealing Gaskets, preventing oil leaks.
5. Screw the remaining Oil Bottle into the Bottle
Cap assembly underneath the Work Table.