Product manual

SKU 93170 For technical questions please call 1-800-444-3353. Page 3
9. Do not force this product. Do not use inappropriate attachments in an attempt to exceed the
Truck Anchors’ capacity.
10. Keep children away. Children must never be allowed in the work area.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking your Truck Anchors, make certain that all parts on page 4 of this manual are
included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
1-800-444-3353.
Installation
Your Truck Anchors will require complete installation. It is important that you read the entire manual
to become familiar with the product BEFORE you install and use the Truck Anchors. Before
installing this product be sure that you have all parts described in the Parts List and Assembly
Diagram located on page 4 of this manual.
Figure 2-Underside View
Truck
recess
Fastening
Plate (4)
Figure 1-Upside Down View of Truck Anchor
2. Set the Truck Anchor down so that the Fastening Plate (4) sets down into the recess in your
truck bed.
3. Turn the Truck Anchor so that the Fastening Plate (4) will be secure against the ridge of the
recess in the truck once it is secured in place-see Figure 2.
4. Using a Phillips Head screwdriver, tighten down the Fastening Screws (3). As you screw
them down, the Fastening Plate (4), Top Plate (1) and Housing Gasket (2) will tighten into
place in the truck bed. Continue to tighten until the Truck Anchor is firmly in place with the
Top Plate, Housing Gasket (2) and Fastening Plate (4) tightly against the truck bed.
Fastening Plate (4)
Fastening Screw (3)
Top Plate (1)
Housing Gasket (2)
1. Insert the two Fastening Screws (3) down through the Top Plate (1) and Housing Gasket (2)
and thread them into the Fastening Plate (4)-see Figure 1.