Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 96290
SAFETYOPERATIONMAINTENANCE SETUP
3. Attach the Green labeled Oxygen Regulator
(not included) to the Oxygen Cylinder and the
green oxygen hose (not included) to the Regulator.
4. Attach the Red labeled Acetylene Regulator (not
included) to the Acetylene Cylinder and the red
acetylene hose (not included) to the Regulator,
tighten counterclockwise - threads are reversed.
5. Torch Handle Setup:
a. Remove the inlet covers.
b. Make sure both Check Valves are
in place on the Torch Handle.
c. Connect the green-oxygen hose to the
oxygen Check Valve on the Torch Handle.
d. Connect the red-acetylene hose to the acetylene
Check Valve on the Torch Handle,
tighten counterclockwise -
threads are reversed.
Check
Valve (OX)
Oxygen Hose
(green)
Check Valve (AC)
Acetylene
Hose (red)
Torch
Handle
Assembly Step 5: Torch Handle Setup
6. Cutting Attachment Setup:
WARNING! BEFORE CONNECTING,
make sure the two
O-Rings on the end of the
Cutting Attachment are
not damaged or missing,
otherwise gases will mix
inside the Torch Handle
and result in flashback
or backfires.
Connect the Cutting Attachment to the Torch Handle.
Then, connect the Cutting Tip to the Cutting Attachment.
Cutting
Attachment
Torch
Handle
Cutting Tip
Assembly Step 6: Cutting Setup
7. Before operation, the leak tests on the
following pages must be done after connection
to check for leaks in the system.
Cutting
Attachment
O-Rings