Product manual

Page 11
For technical questions, please call 1-800-444-3353.
Item 69897
SAFETYOPERATIONMAINTENANCE ASSEMBLY
NOTE:
Only a qualified technician should perform
the electrical service that may be needed to
enable your particular make/model vehicle to
power the Trailer’s 12 volt DC lighting system.
This is beyond the scope of this manual.
34.
Have a qualified service technician install a 4-wire,
12VDC connector in the trunk area of your vehicle.
35.
Locate the vehicle’s connector plug near the
Trailer’s Coupler (2) and lay out the Trailer’s
wiring harness wires.
(See Figure I.)
36.
Connect the brown wire to the vehicle’s Left
Tail Light by stripping, wrapping, and taping
the connector plug.
(See Figure I.)
37.
Connect the yellow wire to the vehicle’s left
signal and stop light wire.
(See Figure I.)
38.
Connect the green wire to the vehicle’s right
signal and stop light wire.
(See Figure I.)
Note
: Some foreign vehicles may require
: Some foreign vehicles may require
and adapter to convert their 5-wire system
to a 4-wire vehicle connector plug.
39.
Attach the white ground wire at the plug
end of the wiring harness to the small hole
on the Coupler Base (3) with a 1/4" tapping
screw (not included).
(See Figure I.)
40.
Leave about 18" of wire beyond the Coupler
(2),
and run the wiring harness along the inside of
the Right Drawbar Rail
(5) to the Front
Right
Side Rail
(27). Then, split the yellow/brown
wires from the green/brown wires.
41.
Run the yellow/brown wires along the
inside of the Front Cross Member
(21) to
the Side Running Light
(45) located on the
Front
Left
Side
Rail
(15). Then, run the green/
brown wires along the inside of the Front Right
Side Rail
(27) to the other Side Running Light.
42.
Connect the wire lead from the two Side Running
Lights to the brown wire on each side of the
trailer, using wire connectors. Then, insert wire
clips along the entire length of the side rails of
the Trailer to hold down the wiring harness.
43.
Run the yellow/brown wires to
the
Left
Tail
Light
(23L). Strip approximately
3/4" of insulation off the ends of the wires.
Connect
the yellow
wire to the yellow wire of
the
Left
Tail
Light. Then, connect the brown
wire to the brown wire of the Left Tail Light.
44.
Run the green/brown wires to
the
Right
Tail
Light
(23R). Strip approximately
3/4" of insulation off the ends of the wires.
Connect
the green wire to the green wire of
the Right Tail Light. Then, connect the brown
wire to the brown wire of the Right Tail Light.