Product manual

Page 8 For technical questions, please call 1-800-444-3353. Item 61487
SAFETY OPERATION MAINTENANCESETUP
Head Assembly to Column
See Figure C.
1. Before installing the Head Assembly, it may be
necessary to back the four Socket Head Cap
Screws (6) out slightly to ensure they do not
protrude internally, as this would prevent the
Head Assembly from sliding fully into position.
2. With assistance, raise the Head assembly
and locate it on top of the Column.
3. Align the Head with the Base, and firmly
secure it with the Set Screws.
4. Screw the three Spindle Feed Handle Bars
(9) firmly into the Spindle Feed Hub (10).
Socket Head
Cap Screws (6)
Belt Tension
Lever (96)
Belt Tension
Locking Knob
(87)
Figure C
Attaching the Pulley Cover Handle
1. Slide the Pulley Cover Handle (118) into
the hole in the front of the Pulley Cover.
2. Put the Cross-Shape Screw (28) through the
Flat Washer (27) and twist it into the Handle
from the inside of the Pulley Cover.
Installing the Cutting Oil System
1. Use four Socket Head Cap Screws (120) and four
Rubber Pads (88) to attach the two Oil Bottle Clips
(121) to the tapped holes in the left side of the Head.
2. Thread the Oil Pipe (76) into the bottom
of one of the Oil Bottles (56), screw an Oil
Bottle Cap (53) onto the Bottle and snap
the Bottle into the Oil Bottle Clips.