Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 61487
SAFETY OPERATION MAINTENANCESETUP
Specifications
Motor 120VAC, 60Hz, 13.5A
Spindle Speeds
220, 290, 360, 430, 500, 570, 640, 730, 810, 900,
1460, 1730, 1820, 2380, 2650, 3600 RPM
Spindle Stroke 2-3/4"
Spindle Taper MT2
Chuck Capacity 7/64" to 5/8" (3mm to 16mm)
Swing 17″
Table Diameter 12-7/8″
Table Rotation 360°
Table Tilt 45° (left and right)
Column Diameter 3-3/16″
227541
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Before assembling and using the Drill Press,
secure the Base to a supporting structure.
1. Verify that the intended installation surface has no
hidden utility lines before drilling or driving screws.
2. Bolt the Base to a flat, level, solid floor
location capable of supporting the weight
of the Drill Press and any workpieces.
Assembly
Column Assembly to Base
1. Attach the Column Support (2) to the Base (1)
using the four M10x35 Bolts (5), four Spring
Washers (4) and four Flat Washers (3).
2. Tighten the Bolts firmly.
3. Insert the Column (7) into the Support
and firmly secure this assembly in
place with the Set Screws (6).
Note: It may be necessary to back the Set
Screws out beforehand, as they may protrude
into the Support tube, preventing the Column
from sliding fully into the Column Support.