Product manual

Page 13For technical questions, please call 1-800-444-3353.Item 61487
SAFETYOPERATIONMAINTENANCE SETUP
Using the Cutting Oil Drip System
1. Remove the upper Oil Bottle from the Oil
Bottle Clips and unscrew the Cap.
2. Make sure that the Oil Pipe valve is closed.
Fill the Bottle with your lubricant of choice.
3. Screw the Cap onto the Bottle and snap
the Bottle back into the Clips.
4. Open the Oil Pipe valve and adjust the Pipe
so the oil drips onto the cutting area.
5. The used oil will collect in the Oil Bottle that is
attached to the underside of the Work Table.
• Dispose of the used oil in accordance
with local regulations.
Installing the Bit
CAUTION! Wear heavy-duty work gloves to provide
protection when inserting and removing drill bits. Drill
bits become very hot during use. Do not remove a drill
bit until it has cooled.
1. Loosen the Chuck with the Chuck Key until the jaws
of the drill are opened enough to fit the drill bit..
2. Insert the drill bit approximately 1″ into
the jaws of the Chuck, ensuring that the
jaws do not touch the flutes of the bit.
3. Hand tighten the Chuck until the bit is held
securely in place. Confirm that the bit is
centered between the Chuck jaws.
4. Use the Chuck Key to tighten the Chuck.
• Insert the tip of the Chuck Key into a hole on the
side of the Chuck so that the teeth on the Key
engage the gear on the Chuck. Use the Key to
tighten the Chuck securely and remove the Key.
NOTICE: Use sharp bits. Dull, bent, or damaged
bits will cause stress on the drill and/or break.
Using the LED Lamp
1. Flip the LED Lamp Power Switch (73)
to turn the LED Lamp (72) on.
2. Use the Lamp's built-in goose-neck to move it
to a position where it illuminates the workpiece
in the area where it is being drilled.
3. Turn off the Lamp after use. Move the
Lamp away from the Chuck before removing
the drill bit and cleaning the tool.