Product manual

Page 12 For technical questions, please call 1-800-444-3353. Item 61487
SAFETY OPERATION MAINTENANCESETUP
Changing Drill Speed
See Functions on page 10 for illustrations.
1. WARNING! TO PREVENT SERIOUS
INJURY: Turn off and unplug the Drill
Press before changing drill speed.
2. Open the Pulley Cover.
3. Loosen the Belt Tension Lock Knobs
on both sides of the Head and turn the
Belt Tension Lever clockwise. This will bring
the Motor Pulley towards the Spindle Pulley,
removing all tension from the drive Belts.
4. Consult Figure F (or the chart inside the
Pulley Cover) and install the Belts on the
Pulleys in the positions that correspond
to the required Spindle/Drill speed.
5. When the Belts have been correctly positioned,
tighten them by turning the Belt Tension Lever
counterclockwise. The tension is correct when
the belts deflect by approximately 1/2″ at their
centers of run when using reasonable thumb
pressure. (See Figure D on page 9.) Lock this
position in with the two Belt Tension Lock Knobs.
Note: If a belt is too long to be properly
tensioned, it must be replaced.
430
730
1730
3600
220
500
810
1820
290
570
900
2380
360
640
1460
2650
Figure F: Belt Speed Settings
Setting the Drilling Depth
See Figure G.
Located around the Spindle Feed Shaft is a Depth
Stop Collar (14) carrying a graduated scale.
The Collar will turn around the Shaft, and can
be locked in place by the Lock Knob (13).
1. With the power to the Drill Press switched OFF, use
the Spindle Feed Handles to lower the drill until the
bit contacts the workpiece and hold it in that position.
2. Loosen the Lock Knob and turn the Depth Stop
Collar so that the measurement for the required
hole depth is aligned with the Pointer (23).
3. Tighten the Lock Knob to lock
the Collar in this position.
Lock
Knob
(13)
Depth Stop
Collar (14)
Pointer (23)
Figure G: Setting the Drilling Depth