Product manual

Page 4 For technical questions, please call 1-800-444-3353. SKU 69259
Assembly
1. Your Laser Level will require some
assembly prior to use. Read entire
manual to become familiar with product
BEFORE you use the Laser Level. Be
sure you have all parts described in
the Parts List and Assembly Diagram
located on the last page of this manual.
2. Unfold Tripod (15) by pulling out on the
Tripod arms. Turn the Knob (17) to lock
the arms in place. See Figure 1, below.
Tripod
(15
)
Figure 1
Knob (17)
Latch
Arms
3. The legs of the Tripod can be raised or
lowered by lifting the latch on the body
of the Tripod and sliding the leg in or out
to the desired height. Push the latch
down into place to Lock the Leg in place.
Repeat for the remaining two legs.
4. Set the Tripod on a flat surface. Once
the Tripod (15) is set up, you can raise
and lower the Rotating Head (7) by
turning the Handle (18) located at the
top of the Tripod. See Figure 2, below.
Handle (18)
Rotating
Head (7)
Tripod
(15)
Figure 2
5. Wind the Handle clockwise to raise the
Rotating Head and counterclockwise
to lower the Rotating Head.
6. Set the Plastic Body (5) into the slot in
the Tripod. See Figure 3, below. Tighten
the Knob (14) on the top of the Tripod
to secure the Plastic Body in place.
Knob (14)
Plastic
Body (5)
Figure 3
Tripod slot
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at
the beginning of this manual
including all text under subheadings
therein before set up or use of
this product.
Initial Leveling
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION: Turn Power
Switch to Off before adjusting Level.
1. Turn the three Adjusting Knobs (16) one
at a time to level the Rotating Head (7).
See Figure 4, below.
Adjusting
Knobs (16)
Vertical Bubble (3)
Figure 4
Horizontal Bubble (4)