Product manual

Page 16 For technical questions, please call 1-888-866-5797. Item 61809
SAFETY OPERATION MAINTENANCESETUP
Clearing Jams
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION,
BEFORE ANY MAINTENANCE OR REPAIRS ARE DONE (including clearing jams):
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Release the Trigger.
• Detach the air supply.
• Attempt to fire the tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
• Empty the Magazine and leave it open during service.
The Magazine is spring-loaded and may cause parts or a fastener to fly out of the tool.
1. If a fastener is jammed in the Magazine,
depress the Magazine Latch (59) and pull
back on the Moveable Magazine (79), sliding
it back to end of Fixed Magazine (85).
2. Use a screwdriver to release the jammed fastener
by probing the openings in the Fixed Magazine.
3. Pull out the jammed fastener and the remainder
of the fastener strip that is still in the Magazine.
Dispose of the remaining fastener strip; it is
likely bent or damaged and may cause repeated
jamming or damage to the tool if reused.
4. If a fastener is jammed in the Drive Guide (77),
push down on the Quick Release Latch (66) and
lift the Drive Guide Cover (74) off the Drive Guide.
5. Remove the jammed fastener; pliers may be
necessary to remove a stuck fastener.
6. Inspect the Drive Guide for any bends or
breakage. If it is damaged, do not use the tool
until it is repaired by a qualified technician.
7. Lightly oil the Drive Guide, replace the Drive
Guide Cover and secure it by snapping the
Quick Release Latch back into place.
8. Make sure that the Safety Nosepiece (63)
moves without sticking.
9. Reload the Nailer/Stapler and then
reconnect it to the air supply.
10. Press the Safety Nosepiece of the Nailer/Stapler
against an appropriate piece of scrap wood.
11. Test fire the Nailer/Stapler several times,
checking for proper operation.
12. Disconnect the Nailer/Stapler, remove the fasteners,
and store in a location out of children’s reach.
13. If the jam cannot be cleared using
the methods above, have the tool
serviced by a qualified technician.