Product manual

Page 14 For technical questions, please call 1-888-866-5797. Item 61809
SAFETY OPERATION MAINTENANCESETUP
General Operating Instructions
1. Before each use, test the tool as directed in
″Single Sequential Safety Trip Mechanism
Testing Procedure″ on page 12.
2. If an automatic oiler is not used, add
a few drops of pneumatic tool oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
3. Attach the Nailer/Stapler to the air supply
at the Air Inlet Plug. Start compressor
and check the pressure, making sure it is
set not to exceed Maximum Air Pressure
indicated on the Specifications Chart.
WARNING! TO PREVENT
SERIOUS INJURY: Keep second hand
away from tool discharge area,
especially if holding workpiece.
tool applies extreme force to fastener,
and fasteners may deflect or fire in
an unexpected direction.
CAUTION! TO PREVENT INJURY: Do not hold tool
near body while firing. Tool recoil can cause injury.
4. To fire, place the nose of the Nailer/Stapler on
the workpiece. The Nailer/Stapler should not fire
if the Safety Nosepiece is not depressed. Once
depressed, gently and briefly squeeze the Trigger
once. Do not fire repeatedly; nails or staples
could bounce off of one another, damaging
the workpiece or causing personal injury.
5. To change the depth setting of the Nailer/
Stapler, turn the Depth Adjustment
Knob to the desired setting.
6. If, at the maximum depth setting, the tool requires
more force to accomplish the task, verify that the tool
receives sufficient, unobstructed airflow (CFM) and
increase the pressure (PSI) output of the regulator
up to the maximum air pressure rating of this tool.
CAUTION! TO PREVENT INJURY
FROM TOOL FAILURE:
Do not exceed the tool’s
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
7. After use, to prevent accidents:
a. Release the Trigger.
b. Detach the air supply.
c. Attempt to fire the tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
d. Release the Trigger again.
e. Clean external surfaces with clean, dry cloth.
f. Store indoors out of children’s reach.