Product manual

Page 13For technical questions, please call 1-888-866-5797.Item 61809
SAFETYOPERATIONMAINTENANCE SETUP
Loading the Tool
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING:
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Release the Trigger.
• Detach the air supply.
• Attempt to fire the tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
1. Depress the Magazine Latch and pull
back on the Moveable Magazine, sliding
it back to end of Fixed Magazine.
Note: This Nailer/Stapler can drive
16 Gauge Finish Nails, 18 Gauge Brad Nails
and Staples. The various type fasteners
are loaded in different ways.
2. To load 16 Gauge Finish Nails, insert the
nails from the top area of Fixed Magazine and
into the center slot. Refer to Figure C.
16 Gauge
Finish Nails
Fixed
Magazine
Figure C
3. To load 18 Gauge Brad Nails, insert the
nails into the channel along the left-side of
the Fixed Magazine. Refer to Figure D.
18 Gauge
Brad Nails
Fixed
Magazine
Figure D
4. To load Staples, insert staples from the top area
of the Fixed Magazine with one arm of the staples
in the center slot and the other arm along the
Fixed Magazine’s left side. Refer to Figure E.
Staples
Fixed
Magazine
Figure E
5. After the nails or staples are loaded, slide
the Moveable Magazine back into the Fixed
Magazine until the Magazine Latch snaps back
in place, securing the Moveable Magazine
and locking the fasteners into place.