Product manual

Page 7For technical questions, please call 1-800-444-3353.Item 60564

SAFETYOPERATIONMAINTENANCE SETUP

Stand Assembly

(continued)

4. Set the Face Plate (1) onto the stand

assembly and fasten to the top SIDE

mounting holes on Front and Rear Legs.

NOTE: Be sure that the belt opening on the Face Plate

is positioned away from the switch. See Figure 4, right.

5. Slide the Inner Plate (9) under the opposite end

of the Face Plate and fasten together using the

TOP mounting holes. Then fasten to the top

middle holes on the Connecting Plate to the other

end of the Face Plate. See Figure 5, right.

6. Set the Fixed Plates (64) against each bottom

corner of the Front and Rear Legs, making sure the

mounting holes face downward. See Figure 6, right.

7. Use the Hex Bolts (53), Flat Washers (58) and

Nuts (60) to fasten the Feet (65-1), Pads (65)

and Fixed Plates together. See Figure 7, right.

8. Make sure Stand is level.

If level, tighten all hardware connections now.

Figure 4

Face Plate (1)

Plate

Assembly

Figure 5

Face

Plate (1)

Inner

Plate (9)

Figure 6

Fixed

Plate

(64)

Figure 7

Hex Bolt (53)

Feet (65-1)

Pad (65)

Fixed Plate (64)

Flat

Washer

(58)

Nut (60)

65-1

58 60