Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 60564
SAFETY OPERATION MAINTENANCESETUP
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
Stand Assembly
Note: During this phase, finger tighten all Nuts to
allow adjustment and leveling. All connections in
this phase are made with one Carriage Bolt (55)
going through the connection from the outside then
being secured with a Washer (58) and Nut (60).
1. Fasten the Connecting Plate (5) to the top
end of the Motor Plate (7). The top end of the
Motor Plate has the shorter flange and the bottom
end has the longer flange. See Figure 1, right.
2. Fasten Supporting Plates (4) to the ends of the Base
Plate (6). Attach the Motor Plate (7) to the end of
the slots in the Base Plate. See Figure 2, right.
3. Fasten the Front Leg (2), the one with the cord to the
left side of the Plate assembly, inserting the carriage
bolts through the Front Leg’s bottom mounting
holes and into the mounting holes on the left of the
Supporting Plate. Then fasten the Rear Leg (3)
to the right side of the Supporting Plate. Then
fasten second Supporting Plate on the other sides
of the Front and Rear Legs. See Figure 3, right.
Figure 1
Motor Plate (7)
Connecting
Plate (5)
Figure 2
Supporting
Plate (4)
Motor
Plate (7)
Base Plate (6)
Figure 3
Rear Leg (3)
Front Leg (2)
Supporting
Plate (4)
55 58 60