Product manual

Page 17For technical questions, please call 1-800-444-3353.Item 60564
SAFETYOPERATIONMAINTENANCE SETUP
Blade Guide Adjustment
1. Loosen the Knob (6A) and set the Bracket Post
as close as possible to the top surface of the
material being cut. See Figure 29, right.
2. Once the Bracket Post is adjusted,
securely tighten the Knob.
Figure 29
Knob
(6A)
Table Angle Adjustment
1. Loosen the two Angle Knobs (46A) underneath
the Table. See Figure 30, right.
2. Tilt the Table to the left or right until the
needle points are set to the desired angle
on the Scale (51A). Once properly adjusted,
securely tighten both Angle Knobs (46A).
Figure 30
Table
(39A)
Angle
Knob
(46A)
Angle
Knob
(46A)
Scale
(51A)
Blade Speed Adjustment
1. Remove the Side Panel and open
the Pulley Box to allow access.
2. Use the Belt Installation instructions
on page 16 to change the Belt’s position
to the desired speed setting.
3. Replace the Side Panel and close the
Pulley Box after changing the speed setting.