Product manual

Page 15For technical questions, please call 1-800-444-3353.Item 60564
SAFETYOPERATIONMAINTENANCE SETUP
5. Position the Saw Blade (36A) through the upper
Blade Guides (11A) and over the Upper Wheel
(24A).
See Figure 25, right.
6. Place the Saw Blade on the
Lower Wheel (67A) and through the lower
Blade Guides (11-1A). See Figure 25, right.
7. Replace the Table Insert and Table Pin.
8. Place the Blade Guard (70A) onto the two Studs
and over the Saw Blade. See Figure 25, right.
WARNING! Replace both Blade Guards (69A and
29A)
and secure them in place BEFORE
operation to prevent serious injury.
Blade
Guide
(11A)
Saw
Blade
(36A)
Figure 25
Blade
Guide
(11-1A)
Upper
Wheel
(24A)
Lower
Wheel
(67A)
Blade
Guard
(70A)
Dust Chute Setup (Optional)
If you wish to attach a dust collector to this
Bandsaw, attach the Dust Chute (94A) to
the Lower Wheel Guard (69A) using the
Screws (95A). See Figure 26, right.
Figure 26
Dust Chute (94A)
Lower Wheel Guard (69A)
Saw Blade Tensioning and Tracking
1. The Saw Blade tension is adjusted using
the Blade Adjusting Knob on the back of
the Inner Wheel Guard (28A). Turn the
Knob clockwise to increase tension and
counterclockwise to decrease tension.
Note: Too much tension is a common
cause of Saw Blade breakage and other
unsatisfactory performance. Relieve the
tension when the Bandsaw is not in use.
2. Adjust Upper and Lower Blade Guides so that they
do not contact the blade during tracking adjustment.
3. Loosen the nut on the shaft of the
Blade Tracking Knob (18A).
Inner Wheel
Guard (28A)
Figure 27
Blade Adjusting
Knob (14A)
Blade Tracking
Knob (18A)