Product manual

Page 13For technical questions, please call 1-800-444-3353.Item 60564
SAFETYOPERATIONMAINTENANCE SETUP
Side Panel Installation
8. Insert the Screws (68) into the
Press Blocks (67) from the smooth side.
9. Attach the Press Blocks to the textured side
of the Side Panel (66) by screwing the Screws
into the mounting holes on the Side Panel.
Leave the Screws just loose enough to allow
the Press Blocks to turn. See Figure 20, right.
NOTE: Do not overtighten - use a screwdriver
when tightening.
10. Position the Press Blocks so that they
point towards the center of the Side Panel.
See Figure 20, right.
11. While holding the Side Panel by the two finger
holes, place it inside the side of the Stand as
shown in Figure 20, right. Rotate the Press Blocks
out and tighten the Screws to secure the Side
Panel in place. Repeat for the other Side Panel.
Figure 20
Side Panel
(66)
Press
Block
(67)
Upper Guide and Post Cover Assembly
1. Assemble the Upper Blade Guard (2A) to the
Bracket Post (5-1A) using the two Hex Head
Bolts (73A) and Flat Washers (74A).
2. Loosen Hex Bolt (3A) on the side of the Bracket
Post.
Slide the Upper Blade Guard up into the
Upper Covers and then the Bracket Post
onto the end of the Guide Post (4A). Align
the Bracket Post and tighten the Hex Bolt
to secure it. See Figure 21, right.
Figure 21
Upper Wheel
Guard (29A)
Upper Blade
Guard (2A)
Bracket
Post
(5-1A)
Hex
Bolt
(3A)
Guide
Post
(4A)
Pulley Cover Assembly and Belt Installation (continued)