Product manual

Page 7For technical questions, please call 1-800-444-3353.Item 61483
SAFETYOPERATIONMAINTENANCE SETUP
Table and Support Arm to Column
1. Remove the Rack (8) from the Column (7)
by loosening the Collar Set Screw (19) and
removing the Collar (18). The Rack is stowed
in this position only for transit purposes.
2. Gently slide the Table Support Assembly over
the Column and hold it steady. With the long
smooth end of the Rack uppermost, insert the
Rack down through the Assembly so it meshes
with the gear inside the Assembly. Locate the
bottom end of the Rack in the groove formed
between the Column Support and the Column.
3. Hold the assembly and Rack in this position
while replacing the Collar on the Column, and
ensure that the top end of the Rack is firmly
engaged in the groove formed between the Collar
and the Column. IMPORTANT: Make sure
the Rack is not pinched and there is a working
clearance between the Rack and Collar.
4. Firmly secure the Collar to the Column
with the Collar Set Screw.
5. Tighten the Arm Locking Handle (23) to secure
the Table Support Assembly to the column.
6. Attach the Table Crank (30) to the
shaft protruding from the Table Support
and tighten its Securing Screw (29).
7. Loosen the Arm Locking Handle and turn the Crank,
testing to ensure that the Support Assembly easily
travels up and down the full length of the Rack
without binding, and that it also rotates freely all
the way around the Column without binding.
8. IF THE SUPPORT ASSEMBLY IS TOO TIGHT:
• Slightly loosen the Arm Locking Handle
and loosen the Collar Set Screw.
• Adjust the Collar slightly to provide a
greater working clearance between
the Rack and the Collar.
• Tighten the Collar Set Screw, and
test the assembly again.
9. Insert the Work Table (25) into its
housing on the Support Assembly and
secure with the Table Clamp (35).
Head to Column
1. It may be necessary to back the Set Screws
(6) out slightly to ensure they do not protrude
internally, as this would prevent the Head
Assembly from sliding fully into position.
2. With assistance, raise the Head assembly
and locate it on top of the Column.
3. Align the Head with the Base, and
firmly secure with the Set Screws.
4. Screw the three Spindle Feed Handle Bars (10)
firmly into the Spindle Feed Handle Seat (64).
Installing the Chuck
1. Loosen Arm Locking Handle (23) and slide the
Table up the Column to within 6″ of the Spindle
(42). Tighten the Arm Locking Handle.
2. Open the jaws of the Chuck (40) to their
maximum, using the supplied Chuck Key.
3. Put a piece of scrap wood on the
table to protect the Chuck nose.
4. Ensuring all parts are thoroughly clean, dry
and burr free, insert the Arbor (41) firmly
into the end of the Chuck with its pointed
end facing away from the Chuck.
5. With the Chuck now attached, insert the pointed end
of the Arbor into the end of the Spindle Shaft (42).
If necessary, rotate the Arbor to ensure that the
point on the end of the Arbor locates correctly
with the drive slot in the Spindle Shaft.
6. Using the Spindle Feed Handles (10),
lower the Spindle and press the Chuck nose
hard against the piece of scrap wood on the
Table to secure the Chuck into place.
Pulley Cover Knob
Attach the Pulley Cover Knob (91) to the
Pulley Cover (92). Screw on tightly.