Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 61483
SAFETY OPERATION MAINTENANCESETUP
Specifications
Spindle Speeds (RPM) 220, 290, 360, 430, 500, 570, 630, 760, 830, 920, 1430,
1620, 1850, 2260, 2580, 3600
Electrical Rating 120VAC, 60Hz, 7.2A, Single-Phase
Drill Chuck Capacity 7/64″ to 5/8″ (3mm to 16mm)
Spindle Stroke 3-1/8″
Spindle Taper MT2
Swing 13-1/2″
Column Diameter 2-3/4″
Table Size 11-3/8″ Diameter
Table Tilt 0º - 45º Left and Right
Table Rotation 360º
Overall Height 62-1/2″
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Before assembling and using the Drill Press,
secure the Base to a supporting structure.
1. Verify that the intended installation surface has no
hidden utility lines before drilling or driving screws.
2. Bolt the Base to a flat, level, solid floor
location capable of supporting the weight
of the Drill Press and any workpieces.
Assembly
Column Assembly to Base
1. With the Base (1) on a flat level surface, bolt on the
Column Support (2) using the four M10x30 Bolts
(5), Flat Washers (3) and Spring Washers (4).
2. Firmly tighten the Bolts.
3. Insert the Column (7) into its Support (2) and firmly
secure it with the Socket Head Cap Screws (6).
Note: It may be necessary to back the Cap
Screws out beforehand, as they may protrude
into the tube, preventing the Column from
sliding fully into the Column Support.
227541