Product manual

Page 7For technical questions, please call 1-888-866-5797.
Item 61788
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch “OFF” and disconnect from power source before
performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM COMPRESSOR FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the air compressor. Check for:
• loose hardware,
• misalignment or binding of parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. AFTER USE, allow the unit to cool,
then wipe external surfaces of the
compressor with a clean cloth.
3. Store the Air Compressor in a clean, dry,
safe location out of reach of children
and other unauthorized people.
4. AFTER EVERY 500 HOURS OF REGULAR USE,
replace O-Rings. Please note: This work should
only be done by a qualified service technician.
5. AFTER EVERY 20 USES, lubricate the Shaft
and Snap Rings. Please note: This work should
only be done by a qualified service technician.
6. Replace the Fuse (1C) when required.
a. Unthread and remove the Bezel (1E), the Contact
Pin (1D), and the Ring (1B). (See Figure A.)
Be careful to not lose any pieces.
b. Slide the Fuse out of the Cigarette Lighter Adaptor.
c. Rest the Ring on the lip of the
Cigarette Lighter Adaptor.
d. Insert a new Fuse through the Ring into
the Cigarette Lighter Adaptor and use it to
press down the internal Spring (1A).
e. Recombine the Bezel with the Contact Pin (the
broad end of the Contact Pin should press
against the Fuse, as in Figure A), and thread
them into the Cigarette Lighter Adaptor.
WARNING! To prevent fire, replace fuse
only with fuse of same type and rating. Do
not replace with any other object.
Cigarette Lighter Adaptor
Spring (1A)
Ring (1B)
Fuse (1C)
Contact Pin (1D)
Bezel (1E)
Figure A
SAFETYOPERATIONMAINTENANCE SETUP