Product manual

Page 9SKU 96687 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Electrical Requirements 120 V~ / 60 Hz
Load Current 140 Watt
Rotations Per Minute 3800
Arbor Diameter 10mm
Power Cord 
Sharpens Blade Sizes 4” - 15-3/4” Diameter
 0 - 25º Left/Right
Mounting Hole Size 3/8” Diameter (4 holes)
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
SET UP INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Risk of accidental starting; resulting in serious personal
injury. Turn the Power Switch of the tool to its “OFF”
position and unplug the tool from its electrical outlet before
assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram near the end of this manual.
Mounting
1.
weight and vibration of the equipment while it is running. Verify that there are
no hidden wires, utility lines, or hardened surfaces beneath the surface of the
intended mounting area before drilling.
Using the holes in the Base (74) as a template, mark the area where the Blade 2.
Sharpener is to be mounted.
Drill four 3/8” holes in the surface and secure Blade Sharpener with appropriate 3.
hardware (not included).
WARNING
REV 10b