Product manual

Page 12SKU 96687 For technical questions, please call 1-800-444-3353.
Center the saw blade and secure it in place. Do not overtighten; the Blade 8.
should still be able to turn. Make sure the blade is level (perpendicular to axis of
the screw).
9. The shaft of diamond grinding wheel is 20mm diameter, and is mounted on the


Base (24).
Adjust the Swivel Arm (63) of the 10.
Saw Sharpener to compensate for
the size of the saw blade. Loosen
the Lock Nut (83), and rotate and/or
extend the Swivel Arm as neces-
sary, so that the saw blade face or
the cutting edge is mounted to-

also have to be moved.
To move the motor, loosen the Screws (49) that secure it to the Base (74) and 11.
slide it along the track to the new position. Tighten Screws. The Motor can be
moved to a variety of positions, depending on the intended size of the blade to be
sharpened, as shown in Figure 2.
To sharpen a
3-1/2” (90mm)
blade the motor
must be moved
backward.
To sharpen a 9”
(230mm) saw
blade the motor
must be moved
forward to avoid
contact with the
Swivel Arm (63).
To sharpen a 15-1/2” (400mm)
saw blade the motor must be
moved forward and the Swivel Arm
adjusted so that the Lock Nut (83)
does not contact the saw blade.
Figure 2
Swivel
Arm (63)
12. For greater stability and accuracy, position the Saw Blade Support (66) as close

Grinder Lock
Cap (22)
Grinding
Wheel (23)
Grinding Wheel
Base (24)