Product manual
Page 5SKU 69626 For technical questions, please call 1-888-866-5797.
3. Verify that all wires are held securely.
4. Plug the “Trunk” Connector (23) into the “Trailer” Connector (18).
5. WARNING! If the Wire Splices (21) are used improperly and damage
the vehicle’s wiring, the vehicles rear lights may fail, resulting in a
trafc hazard. Have an assistant operate the vehicle’s lights while you
carefully check that the vehicle lights and the towing lights all work
properly after installation. If any function of the vehicle or towing lights does
not work, do not drive the vehicle. Carefully inspect the splice connection
and the circuit that failed and repair the problem and retest before use.
6. Disconnect the “Trailer” Connector (18) if the light kit is not going to be used yet.
SET UP
1. To help avoid scratches, clean the mounting locations
and clean the protective labels under the lights.
2. Set the lights on the back of the vehicle being towed so that the RED side
of each light faces backwards. Set the light that has a green wire on the
right side and the light that does not have a green wire on the left side.
3. Make sure all wires are secured with enough slack to prevent binding when
turning, but controlled enough to prevent roadway or moving part contact.
When routing the wires along the trailer, avoid sharp objects, tight corners and
exposure to the elements. Keep away from moving parts. Secure with cable
ties where necessary and use rubber grommets when passing through cut-outs.
4. Plug the “Trunk” Connector into the “Trailer” Connector.
5. WARNING! Have an assistant operate the vehicle’s
lights while you carefully check that the vehicle lights
and the towing lights all work properly.
• Both tow lights should illuminate when the towing
vehicle’s running lights are switched on.
• The tow lights should both light brightly as you apply the brake.
• The tow light with a green wire should blink brightly with the right turn signal.
• The tow light without a green wire should blink brightly with the left turn signal.
If ANY function of the vehicle lights or towing lights
does not work, do not drive the towing vehicle until all
lights are repaired and retested successfully.
6. The tow light kit is now ready for use. It will automatically illuminate when
turn and brake pedal or turn signals in the towing vehicle are used.
7. WARNING! Check light position and function regularly when
towing, especially on rough or uneven surfaces. The magnets
cannot hold the lights to the vehicle in extreme circumstances.