Product manual

Page 3For technical questions, please call 1-800-444-3353.SKU 66095
3. Choose the area to install the bilge pump and
use appropriate hardware (not included) to
secure the screen to the bottom of the bilge.
4. Connect the pump to the screen with the tabs.
5. Install the pump with an automatic oat
switch, power switch, and fuse (none
included) to prevent damage to the pump.
Power Supply
As shown below, connect the pump to a 12V
battery (not included) located in a dry, secure area.
Pump
– +
Battery
Float Switch
Manual
Switch
15A Fuse
+
–
Operation
After reading these instructions, consider the
following points before starting the pump:
1. Verify that the pump rests on
the bottom of the bilge.
2. Verify that the discharge hose is
properly connected. A smooth bore
discharge hose is recommended.
3. Verify that the electrical connection
is a 12 VDC battery.
4. Wiring that may be exposed to moisture
should be sealed with heat shrink tubing.
5. Verify that water and moisture cannot
get near the power supply.
WARNING! If the wire insulation or housing is
damaged, do not use the pump. Repairs should
be done by a electrician to maintain waterproong.
6. Verify that the pump is installed
to prevent dry running.
7. To ensure that the pump works properly,
keep the bottom of the bilge
free from dirt and debris.
Monthly Maintenance
TO PREVENT INJURY FROM ACCIDENTAL OPERATION:
Disconnect Pump from battery before maintenance.
Note: Maintain more frequently in dirty conditions.
1. Clean sludge and debris from
the bottom of the bilge.
2. Rinse the housing off with clean water.
3. Depress the tabs on the sides of the
pump and remove the Screen.
4. Clean the impeller with clean water.
To prevent damage, do not rest the pump
on the impeller or pry on the impeller.
5. Reassemble in reverse order.