Product manual

Page 11For technical questions, please call 1-888-866-5797.Item 69360
General Operating Instructions
1. Change Direction, Clutch, and Gear
settings as desired, see page 8.
CAUTION: To prevent damage, do
not adjust any setting while drill is in
motion.
2. Install bit as explained to the left.
3. Insert Battery Pack into base of tool until
it clicks in place.
4. Place tip of bit against desired location.
Verify that work surface has no
hidden utility lines before drilling or
driving screws.
5. Place one hand over top of housing for
greater tool stability. With other hand
grip handle and squeeze Trigger to
activate motor.
6. Do not force bit. Excessive force will
damage tip and lead to tool failure.
Drill only as deep as needed.
7. To prevent accidents: After use, turn off
the tool and remove the Battery Pack
by pressing on the striped side tabs and
sliding it out. Clean, then store the tool
indoors out of children’s reach.