Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 32888
SAFETYOPERATIONMAINTENANCE SETUP
4. Mark center line of bend on pipe.
5. Slide pipe into Bending Die, lining up center line
marked on pipe with center of Bending Die.
Note: Use only with pipe that fits the bending
die exactly. Pipe will deform significantly if
it does not fit the Bending Die exactly.
1/2"
1/2"
3/4"
3/4"
1"
1"
1-1/4"
1-1/4"
1-1/2"
1-1/2"
2"
2"
1/2"
1/2" NPS
Pipe
Figure D
6. Place Ram Handle over Release Valve.
7. Twist Handle clockwise to close Valve.
8. Insert Handle into Fulcrum, then pump
Handle until pipe reaches Bending Die.
9. Continue pumping slowly until desired angle is
reached. Keep in mind that pipe may rebound
slightly, so you may need to bend very slightly
beyond your desired bend to get the correct
bend. Practice on scrap workpieces first.
1/2"
1/2"
3/4"
3/4"
1"
1"
1-1/4"
1-1/4"
1-1/2"
1-1/2"
2"
2"
Figure E
10. Place Ram Handle over Release Valve.
11. Twist Handle counterclockwise to open
the Valve and lower the piston.
12. Remove pipe. If necessary, remove
Roller(s) to allow room to remove pipe.
13. After use, store indoors out of reach of children.