Product manual

Page 5For technical questions, please call 1-888-866-5797.Item 67649
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to Parts List and
Assembly Diagram on page 10.
Spring Bar Installation
1. Apply some axle grease to the round
end of one Spring Bar (4).
2. Pry one of the Retaining Pin Springs (2a) back,
pulling the Bar Retaining Pin (2b) outwards.
3.
Figure B
Weight
Distribution
Head (2)
Spring
Bar (4)
Hold the Spring back while installing the Spring Bar
into the socket on the Weight Distribution Head (2).
4. Release the Spring, and adjust the Spring
Bar until the spring snaps back into place.
5. Pull on the Spring Bar to make sure it is properly
attached to the Weight Distribution Head.
6. Repeat for the other Retaining Pin Spring
and the other Spring Bar.
7.
Chain (7)
U-Bolt (8)
Washer
(9)
Lock
Nut (10)
Figure C
Remove the Lock Nuts (10) and Washers (9)
from the U-Bolts (8). Place a U-Bolt around
the bottom link of each Chain (7). Insert the
threaded ends of each U-Bolt into the holes at
the end of each Spring Bar, as shown. Secure
with Washers and Lock Nuts.
Hitch Ball Installation
1. Install a properly sized and properly rated hitch
ball into the hole at the top of the Weight
Distribution Head (2).
2. Secure in place using the washer(s) and
nut(s) provided with the hitch ball.
Figure D
Hitch Ball
(sold separately)
Weight
Distribution
Head (2)
SAFETYOPERATIONMAINTENANCE INSTALLATION