Product manual

Page 5For technical questions, please call 1-800-444-3353.Item 69148
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
Note: The Control Lever (102) controls the operation of the Hydraulic Ram unit. To lower
the Ram and Table, squeeze the Control Lever. When the Control Lever is released,
the Ram and Table movement will stop and the table will remain stationary.
Bleeding the Hydraulic Ram
Note: Before using this tool, the hydraulic ram must be
purged of air (called bleeding).
Housing (241)
Filler Bolt
(242)
Figure B
1. Raise the Table (141) with no load. To do this,
first release the Control Lever (102), then
repeatedly pump the Foot Pedal (139).
2. When the table has been raised, remove the
Filler Bolt (242) from the Housing (241). Use a
rag to catch any fluid leaks. Keeping your hands
and tools clean, squeeze the Control Lever while
pumping the Foot Pedal several times rapidly.
3. Release the Control Lever, and pump more
slowly to raise the Table to its full height.
4. Add good quality hydraulic fluid into the opening in
the Housing where the Filler Bolt has been removed.
Fill until the Housing will hold no more fluid.
5. Replace the Filler Bolt and its Seal Washer
(243) into the Housing, tighten, but do not
overtighten to avoid damaging the Washer.
6. Check the condition of the Hydraulic Lift Table before
use. Raise and lower it several times before adding
any load. Be sure that all controls work properly.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Use the Table on a flat, hard, level
surface that is free of debris. Sweep area
clean of dirt and debris if needed.
SAFETYOPERATIONMAINTENANCE SETUP