Product manual
Page 5For technical questions, please call 1-800-444-3353.Dual Ramps
Setup and Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Before loading or unloading turn vehicle’s engine off, set its transmission
in gear or park, engage its emergency brake and block its wheels.
Make sure the Ramps are clean and dry before loading or unloading.
Setup
1. The tailgate the ramps will sit on
and both of the ramps must be
dry and clean. Check for and
tighten any loose hardware.
2. Sit the tongue (angled lip) of the Ramps
on the tailgate. The Tongue Edge must
face down (see Assembly), and fully
contact the truck’s tailgate. Extend the
Safety Chain (not included) on each
Ramp up into the inside of the truck bed;
attach each Safety Chain to a secure
attachment point on the truck chassis.
WARNING! CONNECT SAFETY CHAINS
TO SECURE ATTACHMENT POINTS
WITHIN THE TRUCK BED ABLE TO
WITHSTAND THE PULLING FORCE
OF LOADING. THEY MUST ALSO
BE TAUT ENOUGH TO PREVENT
THE RAMPS FROM COMING OFF
THE VEHICLE BEING LOADED.
3. Pull the loading ramps back until
the chains are tight. The entire
tongue portion of the ramps must
fit onto the tailgate; If not, adjust
the Safety Chains accordingly or
shorter chains must be used.
Chain Adjustment
1. Remove the bolt and washer that
hold the safety chain to the ramp.
2. Reinsert the bolt through a link that
will shorten the chain so the loading
ramp can not be pulled backwards
more than an inch or two.
3. Make sure the washer prevents the bolt
from slipping through the chain link
and tighten the bolt securely.
4. Adjust the other chain to equal length.