Product manual

Page 4 For technical questions, please call 1-800-444-3353. Dual Ramps
Tongue
Edge
Correct
Wrong
REV 03d, 07k, 10g
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 10.
Flange
TOP
END VIEW
WARNING! In the following assembly
process, the flange pictured above must
face down with the Tongue (2) edge fully
contacting the tailgate. It is designed
to keep the Ramps from moving once the
weight of the load is riding on the ramps.
1. Line up the four holes on the Tongue (2)
with the four holes on the Ramp (1).
Insert four Bolts (3) from the top
(as pictured on the Assembly Drawing)
and secure with Flat Washers (6),
Lock Washers (4), and Nuts (5).
2. Attach a 5/32″ grade 30 coil chain to
one of the side holes of the ramp near
the Tongue, using a M6 x 20 Bolt and
M6 Lock Nut (all sold separately).
3. Repeat with other ramp.