Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 68827
SAFETYOPERATIONMAINTENANCE SETUP
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting Table Saw
If mounting onto a metal table stand:
1. Select a table stand which will support
the weight of the Table Saw. Follow the
table saw stand instructions for assembly.
Tighten all connections, making sure the
assembled table is secure and balanced.
2. Mount the Table Saw to the top of the
assembled Stand using the four Bolts (206),
eight Washers (207) and four Nuts (96).
If mounting onto a bench or
other wooden surface:
1. Select four 3/8″ Bolts, eight 3/8″ Washers, and four
3/8″ Nuts* (not included).
*Screws and washers may be used instead, if desired.
2. Place the Table Saw where it will be mounted.
Make a mark in the center of each of the
4 mounting holes. Set the Saw aside.
3. WARNING! Before drilling the holes, make sure
that there are no electric wires, cables, utility lines
or other obstructions in the area to be drilled.
4. Drill the holes straight down, large enough
to allow your mounting hardware to t.
5. Put the Saw in place and mount
using the hardware mentioned above.
Tighten all hardware securely before use.
Installing Push-Stick Brackets
Use Screws (1) to attach the Brackets (138)
to the side of the Table Saw.
Figure B
Bracket
(138)