Product manual

Page 13For technical questions, please call 1-888-866-5797.Item 68827
SAFETYOPERATIONMAINTENANCE SETUP
Adjusting the Width Of Cut
Graduated
Scale
Guide
(196)
Fence
(194)
Fence Handle
(203)
Figure S
WARNING! Do not attempt to use the fence
and miter gauge at the same time.
1. The width of a cut is achieved by moving
the Fence (194) to the right or left.
2. The Table Saw features a Graduated Scale on
the front of the unit. The Scale’s measurements
are in both inch and metric increments.
3. To adjust the position of the Fence, raise the
Fence Handle and slide the Fence along the
Work Table. Once the position is adjusted, lower
the Fence Handle to lock the Fence in place.
4. To adjust the Fence position using the
workpiece and the Graduated Scale:
a. Place the workpiece against the
Fence on the Table Saw.
b. Raise the Fence Handle to unlock the
Fence and slide the workpiece and Fence
together to the right or left until the left side
of the Guide (196) aligns with the desired
measurement on the Graduated Scale.
c. Lock the Fence in place by lowering
the Fence Handle (203).
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.