Product manual

Page 11For technical questions, please call 1-888-866-5797.Item 68827
SAFETYOPERATIONMAINTENANCE SETUP
Attaching Blade Guard
TO PREVENT SERIOUS INJURY: Unplug the Table Saw before this procedure.
BLADE GUARD MUST BE INSTALLED BEFORE USE.
Figure M
Guard Locking Lever (75)
Blade Guard
Riving
Knife
(45)
1. Set the Blade Guard against the top of the
Riving Knife so that the Rollers (76, 86) slide into the
slot at the top of the Riving Knife. See Figure M.
2. Pull down on the Guard Locking Lever (75),
fastening the Blade Guard in place.
3. Make sure the Blade Guard is fully engaged,
aligned properly and does not contact the Blade.
Attaching and Adjusting the Fence
WARNING! Before installing the Fence,
make sure the Table Saw is disconnected
from its electrical power source.
Fence (194)
Work Table (133)
Fence
Handle
(203)
Rear
Plate
(191)
Figure N
1. To attach Fence (194) to Work Table (133),
raise the Fence Handle (203) and slip the
Rear Plate (191) of the fence over the
back edge of the Table. See Figure N.
2. Lower the Fence all the way onto the Table and
lock in position by lowering the Fence Handle.
3.
Figure O
To adjust the position of the Fence, raise
the Fence Handle and slide the Fence
along the Work Table. Once position is
adjusted, lower the Fence Handle to lock
the Fence in place. See Figure O.
4. WARNING! Make sure fence is perfectly
parallel to the blade and completely
locked in place to prevent kickback.
WARNING! Do not use fence when cutting
across wood grain (crosscutting).