Product manual

Page 10 For technical questions, please call 1-888-866-5797. Item 68827
SAFETY OPERATION MAINTENANCESETUP
Adjusting Riving Knife
TO PREVENT SERIOUS INJURY: Unplug the Table Saw before this procedure.
NOTE: The Riving Knife (45) follows the saw blade
to keep the kerf (gap) from closing on the saw blade.
Reposition the Riving Knife before initial use.
Adjusting
Lever (62)
Riving
Knife (45)
Figure H
1. With the Table Insert removed, rotate the
Adjusting Lever up and pull the Riving Knife out
slightly to disengage the tabs on the Fixing Board.
This will allow the Riving Knife to slide up and down.
Fixing
Board (57)
Riving
Knife (45)
Figure I
2. Bring the Riving Knife up so that the
bottom mounting holes are set against
tabs on the Fixing Board (57).
Adjusting
Lever (62)
Riving
Knife (45)
Figure J
3. Pull the Adjusting Lever forward,
locking the Riving Knife in its new position.
4. Once the Blade is installed and the
Riving Knife adjusted to its working setting,
replace the Table Insert.
Riving
Knife (45)
Table Insert
(130)
Saw Blade (42)
Figure K
NOTE: Install a the Dado Insert (186) if using a
dado blade. This will allow for wide (dado) cuts.
5. Follow safe work practices when stacking dado
blades. Follow the directions of the blade
manufacturer during dado cuts. Do not exceed .5″
stacked dado blade thickness. All mating faces
must be clean and free of sawdust and debris.
Installing Anti-Kickback Pawls
Figure L
Pawl
Block (66)
Pawl Knob (63)
Pawls (72)
Riving
Knife (45)
1. Pull out the Pawl Knob (63).
2. Set the Pawl Block onto the rear mounting
hole on the top of the Riving Knife.
3. Pivot the Pawl Block against the Riving Knife
until the Pawl Knob snaps back into place.