Product manual

Page 4Item 96136
For technical questions, please call 1-888-866-5797.
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Switch of the Measure Wheel is in its “OFF” position
before performing any inspection, maintenance, or cleaning procedures.
2. BEFORE EACH USE, inspect the general condition of the tool. Check for loose
screws, cracked or broken parts, and any other condition that may affect its safe
operation. If anything abnormal is noticed have the problem corrected before further
use. Do not use damaged equipment.
TROUBLESHOOTING
Problem Possible Causes Probable Solutions
Display will not
show in Display
Window
1. Batteries are bad or installed incorrectly.
2. On/Off Button not in ON position.
1. Check Batteries and replace them
if they are bad. Pull them out of the
Battery compartment and check for
correct polarity alignment.
2. Check the On/Off Button