Product manual

Page 3For technical questions, please call 1-888-866-5797.Items 41188 69513
Assembly Specific Safety Information
1. Assemble completely according to instructions
and install Height Pins and R-pins before use.
Improper assembly can create hazards.
2. Assemble or adjust height
only with assistance.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the
area during assembly.
5. Do not assemble when tired or when under
the influence of drugs or medication.
6. Weight capacity and other product
capabilities apply to properly and
completely assembled product only.
7. Inspect the gantry crane as explained
in Frequent Inspection on page 14
after assembly but before use.
Operation Specific Safety Information
1. Use on a hard, smooth, level surface
only. The surface the gantry crane
rests on must be designed to withstand
the loads and forces imposed by the
gantry crane for the rated load.
2. Use in location that allows the operator
to move and stay clear of the load.
3. Use warning signs and barriers on the floor
beneath the gantry crane where overhead
maintenance work creates a hazard.
4. Wear ANSI-approved safety goggles,
ANSI-approved hard hat, and steel-toed work
boots during setup and use.
5. This product is not a toy. Do not allow
children to play with or near this item.
6. Use as intended only.
Do not use to handle molten material.
Do not use for aircraft purposes.
7. Use crane at lowest height
possible for the application.
8. Do not adjust height while under load.
9. Do not move loaded crane.
Inspection, Testing, and Maintenance
Specific Safety Information
1. Perform a “Frequent Inspection”
at least monthly, see page 14.
2. Perform a “Periodic (Thorough) Inspection”
at least yearly, see page 14.
3. More frequent inspections are needed for
gantry cranes that are used heavily.
4. Raise test loads only to the minimum
extent needed and stay well clear of
load at all times during testing.
SAVE THESE INSTRUCTIONS.
SAFETYOPERATIONMAINTENANCE ASSEMBLY