Product manual

Page 10 For technical questions, please call 1-888-866-5797. Items 41188 69513
Operation
TO PREVENT SERIOUS INJURY and DEATH: The use of gantry cranes is subject
to certain hazards that cannot be met by mechanical means, but only by the
exercise of intelligence, care, common sense, and experience in anticipating
the motions that will occur as a result of operating the controls.
Wear ANSI-approved safety goggles, hard hat, heavy-duty work gloves,
and steel-toed work boots during operation.
Do not use without Height Pins in place and secured with R-Pins.
Do not exceed 1 Ton (2000 lb.) capacity.
The Gantry Crane can be used with a Beam Trolley and a Hoist offered by Harbor Freight Tools.
Install trolley and hoist (both sold separately) according to manual instructions before operation.
Adjusting I-Beam Height
CAUTION! Use two people to
adjust the I-Beam height.
1. Remove R-Pins (18) from Height Pins (7),
then remove Height Pins.
2. Turn the Handles on both Winch
Boxes at the same time:
a. Clockwise to raise I-Beam.
b. Counterclockwise to lower I-Beam.
CAUTION! To reduce the risk of tipping,
use crane at lowest height
possible for the application.
WARNING! Do not adjust the
legs to different heights.
3. Once the desired height
has been reached, reinsert Height Pins
and secure in place with R-Pins.
Height
Pin (7)
R-Pin
(18)
Figure J
SAFETY OPERATION MAINTENANCEASSEMBLY