Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 61858
Operating Instructions
Read ENTIRE IMPORTANT SAFETY INFORMATION section at beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: Once Assembly is complete, tighten ALL Bolts before initial operation.
Lifting and Lowering
1.
3/8 Ton Load
Figure K
Locate the hole on the Boom with a weight limit
higher than the weight you will be lifting.
For example: Locate the 1/2 TON
hole on the Boom for a load that is
under 1/2 Ton. See Figure K.
2.
Figure L
Boom Pin
R-Pin
Adjust the Boom Extension
so the hole farthest from the
hook-end aligns with the chosen hole on the
Boom. Secure into place by inserting the Boom
Pin through all aligned holes and securing in
place with the R-Pin. See Figure L above.
WARNING! Keep clear of the object that is being
lifted by the Engine Crane. Be aware of the possibility
of a load slipping off the Hook and Chain. An item
that falls from the Crane can cause serious injury.
3. Move the Crane so that the Hook and Chain
are directly above the item to be lifted.
4. Securely attach the Hook and Chain to the item.
5. To raise the Boom, turn the Ram’s release valve
fully clockwise (right). Insert the Handle into the
Ram and pump (up and down) repeatedly until
the item has been lifted to the desired height.
WARNING! Fully tighten the release valve
or else the Ram may lower or may not
be able to reach the full height.
6. To lower the Crane, SLOWLY turn the Ram’s
release valve counterclockwise (left).
Folding the Frame
WARNING! Do not fold the Crane while loaded.
1. Lower the Crane all the way.
2. Remove R-Pins from the Front Lock Pins. Remove
the front Lock Pins. Leave rear Lock Pins in.
3. Raise the Legs, then reinsert Front
Lock Pins and reinsert R-Pins.
Bleeding Instructions
IMPORTANT! Before first use, check for proper
hydraulic oil level and thoroughly test the
equipment. If it does not work properly, bleed
excess air from its hydraulic system as follows:
1. Open Release Valve and lower Ram completely.
2. Remove Oil Plug and fill with hydraulic
oil (sold separately) to full level.
3. Apply downward pressure to the Boom and
Pump the Ram Handle quickly several times.
4. Check the Oil Fill Hole and, if necessary, top
off the Oil Fill Hole with hydraulic oil.
5. Replace the Oil Plug and close the Release Valve.
6. Test the equipment several times for proper operation
before attempting to lift a load. If, after bleeding,
the equipment still does not appear to be working
properly, do not use the equipment until it has
been repaired by a qualified service technician.
SAFETYOPERATIONMAINTENANCE SETUP