Product manual

Page 9For technical questions, please call 1-800-444-3353.Item 69033
The Backstop
The Backstop supports the Sanding Belt for sanding flat
surfaces. It is held in place on the Frame with two screws
through the opening in the Belt Table. To sand curved
surfaces, remove the Backstop, or back it away from the
Sanding Belt.
Disc Setup
Disc Table Assembly / Removal
Disc Table
Handle
Pointer
Pin
Slot
Hole for
Handle
Assembly
Disc Guard
Disc Chute
Adjustment
Screw for
Disc Guard
Figure I
1. To remove the Disc Table Assembly:
a. Unthread and remove the Handles
on both sides of the Disc Table.
b. Lower the Table and slide it away from the
Sanding Disc and remove it from the Sander.
2. To install the Disc Table Assembly:
a. Align the pins in the Disc Table with
the slots on the Disc Guard.
b. Slide the Disc Table Pins up and in and attach
in place with the Handle Assemblies.
3. Check that the Disc Table is 1/16" or less
from the Sanding Disc. To adjust:
a. Loosen the Adjustment Screws on the Disc Guard.
b. Slide the Disc Guard / Disc Table assembly to
the desired distance from the Sanding Disc.
c. Tighten in place.
Dust Chute Removal
1. Unthread and remove the four Screws
holding the Dust Chute in place and remove
the Dust Chute, Screws and Washers.
2. When reinstalling the Dust Chute, position the
opening facing the back of the unit, as shown at right.
Installing Sanding Disc
1. Remove the Disc Table Assembly and
the Dust Chute as described above.
2. Pull off the old Sanding Disc by
peeling it from the Disc Plate.
3. Clean any saw dust or debris from
around the Disc Plate.
4. Press a new PSA Sanding Disc onto the Disc Plate.
5. Replace the Disc Table Assembly
and the Dust Chute.
6. Loosen the Disc Guard adjustment bolts, adjust the
Guard so the table is 1/16" away from the Sanding
Disc, then tighten the Disc Guard Adjustment Bolts.
7. Tighten all handles and screws.
Backstop
Sanding
Belt
Figure H
Figure J
SAFETYOPERATIONMAINTENANCE SETUP