Product manual

Page 8 For technical questions, please call 1-800-444-3353. Item 69033
Adjusting Belt Tracking
Figure E
Tension
Adjustment
Knob
Adjusting Bolt
1. Remove the Guards, Belt Cover and Belt Table.
2. Plug the unit in and momentarily turn it on and off.
CAUTION: Stand to the side of the belt.
Only turn unit on momentarily.
3. Unplug the Power Cord and wait for the
unit to come to a complete stop.
4. Check to see if the Belt is centered
on all three wheels.
5. If the Belt needs adjustment, turn the Adjusting
Bolt counterclockwise if the belt is left of center,
and clockwise if the Belt is right of center.
Note: Make the adjustments in small
increments, then test again.
6. Repeat steps 2 - 5 until the belt is
centered on all three wheels.
7. Replace the Guards, Belt Cover and Belt Table.
Installing / Adjusting the Belt Table
Screw
and
Spring
Handle
Locking
Nut
Frame
and Table
Washer
Bolt
Figure F: Installing Handle
Table
Lock
Handle
Combination
Square
(sold separately)
Belt Table
Set
Screw
Figure G: Adjusting the Belt Table
The Belt Table is held in place with the Table
Lock Handle and adjusted for level with the
Set Screw at the back of the Table.
1. To install the Table Lock Handle and Table:
a. Slide the Bolt from the inside to the outside of the
Frame, then slide the Washer onto the Bolt end.
b. Position the Table in place then thread the
Locking Nut onto the Bolt as far as it will go.
Note: Hold the Table at the desired position
while tightening the Locking Nut.
c. Slide the Handle onto the Locking Nut and
secure in place with the Spring and Screw.
2. To adjust the Belt Table for use:
a. Loosen the Handle by pulling it out and
repositioning it so you can slide the Belt
Table forward or backward until it is
1/16" from the front of the Sanding Belt,
but not touching the Sanding Belt.
b. Use a Combination square (sold
separately) to set the table at 90°.
c. Lock into position by tightening
the Table Lock Handle.
d. Turn the Set Screw until it touches
the Sander Frame.
3. To tilt the Belt Table for bevel sanding. Loosen
the Table Lock Handle and tilt the Belt Table
forward then tighten the Table Lock Handle.
Belt Setup (cont.)
SAFETY OPERATION MAINTENANCESETUP