Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 69033

Specifications

Electrical Rating 120V~ / 60Hz / 2.5A

Motor No Load Speed 3450 RPM

Max. Accessory Diameter

Disc - 5" D

Belt - 1"W x 30"L

Setup - Before Use:

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its

electrical outlet before assembling or making any adjustments to the tool.

Note: For additional information regarding the parts listed in the following pages,

refer to the Assembly Diagram near the end of this manual.

Assembly/Mounting

Mounting Sander to work table (sold separately)

Figure A

Bolt

Flat Washer

Rubber Washer

Workbench

Sander

Nut

1. Choose a level location with enough room on all

sides to use the Sander. The workbench or table

must be able to withstand the weight of the Sander

and any tools or workpieces. Check that the electrical

cord will be routed along a safe route to reach the

work area without creating a tripping hazard or

exposing the power cord to possible damage.

Note: This sander is designed to be used on

horizontal surfaces only. Do not mount vertically

or at an angle. Motor damage may result.

2. Remove the four feet from the Sander.

3. Place the Sander in position and mark the

location through the four mounting holes.

4. Remove the Sander and drill four 3/8″

diameter holes at the markings.

5. Secure in place with the hardware (sold

separately) as shown at left.

Note: Hardware must be strong enough to withstand

the weight and pressure of the Sander.

SAFETY OPERATION MAINTENANCESETUP