Product manual

Page 12 For technical questions, please call 1-800-444-3353. Item 69033
Sanding Tips
Clean the Sander and area around the Sander of dust and debris when changing grits or materials to sand.
WARNING! Before working with a metal workpiece, thoroughly clean the Sander and area around the Sander of
wood or other non-metal dust and debris. Sparks from the metal surface could ignite debris and cause a fire.
Disc Sanding Tips
1. Always use the Sander on the downward
rotating half of the Sanding Disc.
2. Use the Sanding Disc for sanding the ends of small
and narrow workpieces and outside curved edges.
3. Contact the sanding surface with light pressure,
keeping aware of what part of the disc you are
contacting. The outer edge of the disc moves faster
and removes more material than the area of the
Sanding Disc closer to the center of the Disc.
Belt Sanding Tips
1. Use the Belt Sanding surface to sand wood,
deburr metal, or polish plastic or glass.
2. When sanding flat surfaces, keep the
Backstop installed so the workpiece
contacts a straight flat sanding surface.
3. When sanding curved surfaces, remove the Backstop
or back it off, so the Belt will have some give, and will
better contact the curved edges of the workpiece.
4. When sharpening a metal tool:
a. Keep the Backstop in place for
a firm sanding surface.
b. Adjust the Belt Table to the
desired angle of the Tool.
c. Hold the tool firmly on the Belt Table top and
slide the tool toward the sanding surface making
light contact until the bevel is sharpened.
SAFETY OPERATION MAINTENANCESETUP