Product manual

Page 10 For technical questions, please call 1-800-444-3353. Item 69033
Adjusting the Disc Table Angle
Combination
Square
(sold separately)
Handle
Handle
(on other
side)
Figure K
1. To set the Disc Sander for a 90°:
a. Loosen the Handles on both
sides of the Disc Table.
b. Use a Combination square (sold
separately) to set the table at 90°.
c. Lock into position by tightening the Handles.
2. To tilt the Disc Table for bevel sanding
(0° - 45°):
a. Loosen the Handles on both
sides of the Disc Table.
b. Tilt the Table to the desired angle.
c. Lock into position by tightening the Handles.
Adjusting the Miter Guide
1. Loosen the Knob on the Miter Guide and
rotate the Gauge to the desired angle. The
Miter Guide can be set from 0° to 45°.
2. Tighten the Knob in place.
3. Place the Miter Guide in the groove on the Disc Table,
facing either direction as needed for the project.
Functions
ON/OFF Switch
Upper
Belt Guard
Lower
Belt Guard
Sanding Disc
Tension Knob
Disc Guard
Sanding Belt
Disc Table
Belt Table
Lock Handle
Disc Table
Lock Handle
Miter Guide
Base
Belt Table
Figure L
SAFETY OPERATION MAINTENANCESETUP