Product manual

SKU 94768/69/70/71 For technical questions, please call 1-800-444-3353. Page 4
67650
Pull up on the Trigger and lift up on the 6.
Handle.
With assistance, place the Ball Coupler over 7.
the vehicle’s Tongue ball and pull back on the
Trigger and push down on the Handle until
the Trigger locks in the slot. Pull up and down
on the Coupler to make sure the Tongue ball
is fitting snugly in the Coupler. There should
be no play between the Tongue ball and the
Ball Coupler.
Attach a Safety Pin and “R” Pin (both not 8.
included).
Attach each side of the Safety Chain (not 9.
supplied) equally to the towing vehicle’s rear
bumper or frame.
CAUTION: If there is play, tighten the Adjustment
Nut until no play is present. If the Adjustment Nut
is too tight, the Handle will not lock. Failure to
properly adjust can result in uncoupling.
After the Adjustment Nut is properly adjusted,
pull back on the Trigger and push down on the
Handle until the Trigger locks in the slot. Pull
up on Handle firmly to make sure the Trigger is
locked in place and the Handle cannot move.
MAINTENANCE
Before each use, 1. inspect the general
condition of the Trailer. Check for loose
Bolts and Nuts, misalignment or binding of
moving parts, cracked, bent, or broken parts,
excessively worn Safety Chain, damaged Tail
Lights/Side Running Lights/Wiring Harness,
loose Lug Nuts, loose Tongue connection,
and any other condition that may affect its
safe operation. If abnormal noise or vibration
occurs, have the problem corrected before
further use. Do not use damaged equipment.
Before each use check the Ball Coupler for a 2.
tight fit on the hitch ball as described in the
“Caution” on this page.
There are no customer replaceable parts on 3.
the Ball Coupler.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER
THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR
SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THat ALL
REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO
THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS
THERETO.