Product manual

Page 6 For technical questions, please call 1-888-866-5797. ITEM 60622
SAFETY SETUP OPERATION MAINTENANCE
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that
can start fires around dry vegetation.
A spark arrestor may be required.
The operator should contact local fire
agencies for laws or regulations relating
to fire prevention requirements.
At high altitudes, the Engine’s carburetor, governor
(if so equipped), and any other parts that control
the fuel-air ratio will need to be adjusted by a
qualified mechanic to allow efficient high-altitude
use and to prevent damage to the Engine and
any other devices used with this product.
The emission control system for this Engine is
warranted for standards set by the U.S. Environmental
Protection Agency and by the California Air Resources
Board (also known as CARB). For warranty
information, refer to the last pages of this manual.
IMPORTANT! Your Warranty is voided if either:
1. You operate the Auger without the proper
25:1 fuel/oil mix in its Fuel Tank. Do not run the
Engine with an improper fuel mix, low or no fuel mix.
Running the Engine with an improper fuel mix,
low or no fuel mix, will permanently damage the unit.
2. You operate the Auger without the proper
amount of SAE 80-90 gear oil in its Gearbox.
Do not run the Auger with low or no gear oil.
Running the Auger with low or no gear oil
will permanently damage the unit.
3. You operate the Auger without adding fuel
stabilizer to the gasoline. Do not run the
Engine without treating the gasoline with fuel
stabilizer. Follow fuel stabilizer manufacturer’s
recommendations for use. Running the
Engine without treating the gasoline with fuel
stabilizer will permanently damage the unit.