Product manual

Page 8 For technical questions, please call 1-888-866-5797. Item 61509
SAFETY OPERATION MAINTENANCESETUP
Specifications
Electrical Rating 120VAC / 60Hz / 1A
Speed 12,000 OPM
Dust Chute 1
1
/
4
″ OD
Sandpaper Pad 4″ W x 4
1
/
2
″ L
4005695
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Switch is in the off-position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following
pages, refer to Parts List and Diagram on page 11.
Assembly
Dust Collection Setup
1. Turn the Chute so that the tab on
top of the rectangular end faces up.
Snap it in place into the rectangular
shaft at the back of the Sander.
2. Connect a 1-1/4″ dust collection hose
from the Chute to your dust collection
system (hose and system not included).
3. The Dust Collection Chute will only work
if the sandpaper has holes that line up
with the 6 dust collection holes in the
Backing Pad. (There are 4 other holes
in the Backing Pad for the Screws.)
Functions
Clamp
Dust
Chute
Power Cord
Switch
Backing Pad