Product manual

Page 10 For technical questions, please call 1-800-444-3353. Item 61482
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and
release the trigger before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained within this
manual. Improper adjustment can result in tool failure or other serious hazards.
Priming:
1. Remove the Base Cover (52) and use the
Wrench (51) to unscrew and remove the Air
Cylinder Cap (46) from the bottom of the Riveter.
2. Use a pair of pliers (not included) to
grasp the Nut (44) and remove the Piston
Head (42) from the Air Cylinder (22).
3. Hold the Air Cylinder upside down, and pour
in hydraulic fluid (not included). The fill level
should only reach the top of the Housing (15).
4. Insert the Piston Head back into the Air Cylinder.
5. Use the Wrench to firmly screw the Air
Cylinder Cap back onto the Air Cylinder.
6. Replace the Base Cover.
Wrench (51)
Bottom of Air
Cylinder (22)
Air Cylinder (22)
Lock Nut (39)
Piston Head (42)
Air Cylinder
Cap (46)
Figure C: Priming the Cylinder
Nut (44)
Nosepieces:
1. The Riveter comes with four Nosepieces:
(1A = 1/4"), (1B = 3/16"), (1C = 5/32"), (1D = 1/8").
Nosepieces are stored in the Air Cylinder Cap.
2. Use the Wrench (51) to remove the
old nosepiece and install the new one.
Tighten the new nosepiece in place before use.