Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 60732
Operating Instructions
Read ENTIRE IMPORTANT SAFETY INFORMATION section at beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: Once Assembly is complete, tighten ALL Bolts before initial operation.
Bleeding Instructions
IMPORTANT! Before first use, check for proper hydraulic
oil level and thoroughly test the Crane. If it does not work
properly, bleed air from its hydraulic system as follows:
1. Remove Oil Fill Plug. Fill with hydraulic oil
(sold separately) to full level, if necessary.
2. Open Release Valve by turning
counterclockwise with Ram Handle.
3. Insert Ram Handle into Fulcrum, apply
downward pressure to Boom, then pump
Handle quickly several times.
4. Check oil level and, if necessary,
top off with hydraulic oil.
5. Close Release Valve and replace Oil Fill Plug.
6. Test Crane several times for proper operation
before attempting to lift a load.
7. If, after bleeding, the Crane still does not
appear to be working properly, do not use until
repaired by a qualified service technician.
Operating the Crane
WARNING! The Boom Extension has four positions. Each position has a weight capacity marked
on the Boom. Do not lift more than rated capacity. Be aware of dynamic loading! Sudden load
movement may briefly create excess load causing product failure and serious bodily injury.
Oil Fill
Plug
Release
Valve
Hook and
Chain (18)
Boom
Extension
(15)
Ram
Handle (19)
Post (7)
Large Lock
Pin (9)
Small Lock
Pin (13)
Boom (14)
1000 LB
700 LB
600 LB
500 LB
Fulcrum
Figure G
SAFETY OPERATION MAINTENANCESETUP