Product manual

Page 8 For technical questions, please call 1-800-444-3353. Item 69947
SAFETY OPERATION MAINTENANCESETUP
Specifications
Electrical Rating 120V~ / 60Hz / 4.2A
No Load Speed 2572 RPM
Chuck Capacity 1/16″ - 1/2″
4001254
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following
pages, refer to Parts List and Diagram on page 14.
Assembly
1. Loosen the grip on the Side Handle (33) and
slide Side Handle clamp over and behind
the Chuck (2) until it is set against housing.
2. Rotate the Side Handle until it
is in desired orientation.
3. Rotate Side Handle grip clockwise to secure it.
4. To install the Depth Gauge (32),
loosen the Side Handle and slide the
Depth Gauge into the gauge hole.
5. Set Depth Gauge to required
depth and retighten grip to
fasten Depth Gauge into place.
(See further Depth Gauge explanation
under General Operating Instructions.)
Figure C: Functions